Wayne SYLT30 Operations Instructions download pdf (Page 2)

3. Place pump assembly inside tank,

keeping ﬂ oat away from the walls of

the tank.

4. Run power cord and switch cord

through holes in the power cord seal.

5. Insert seals into the holes in the lid as

shown in Figure 2.

6. Lubricate discharge pipe and seal

with soapy water.

7. Slide the lid (while holding the

discharge seal in place) over the

discharge pipe.

8. Line up the holes in the lid with the

threads in the tank.

9. Secure lid to tank using the screws

and washers provided. (See Figure 3)

Hand tighten all screws and then fully

tighten with a 7/16 in. wrench. Do

not over-tighten.

Installation

Tools Required for Installation (not

included): PVC Glue, 7/16 in. wrench and

a screwdriver.

1. Connect discharge pipe (See Figure 4)

on Laundry Tray System to an existing

drain. Make sure all connections are

sealed.

2. Insert 1-1/2 in. Schedule 40 PVC pipe

into vent opening on top of Laundry

Tray System (See Figure 4). Insert pipe

2 to 3 inches into vent opening.

3. Connect Intake of this Laundry Tray

System (See Figure 4) to your washing

machine or other source. The threads

are 1-1/2 in. NPT.

2

Operating Instructions and Parts Manual

www.waynepumps.com

Support pump and

piping when

assembling and after installation. Failure

to do so could cause piping to break,

pump to fail, etc. which could result in

property damage and/or personal injury.

4. Protect electrical cord from sharp

objects, hot surfaces, oils, and

chemicals. Avoid kinking the cord and

replace damaged cords immediately.

NOTE: Make sure there is adequate room

for the float switch to move freely for

operation.

This pump is NOT

designed for use in

septic tanks or underground vaults to

handle raw sewage or efﬂ uents. NEVER

use this unit in hazardous or explosive

locations.

Assembly (continued)

Figure 2: Attach Seals to Tank Lid

Figure 3: Attach Seals to Tank Lid

P

V

C

Figure 4: Installation

Discharge

Ventilation

GFCI

Outlet

Water

Inlet

Check Valve

Keep ﬂ oat free of

obstruction

Place the system

on a ﬂ at surface

1 2 3 4 5 6 7 ... 19 20

Comments to this Manuals

No comments