Wayne 3018DLX Owner's Manual download pdf (Page 17)

Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need

You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com

Installation of Wiring for Wired

Infrared Safety Sensor

Tools Needed:

Hammer

Uncoil the wires from the infrared safety

sensors and route the wire up the garage

wall across the ceiling and down to the

back of the opener. Tack the wires in place

using staples. Take care to run the wires in

a location where they will not interfere with

the operation of the door and do not staple

through wire.

NOTE: If wires must be lengthened or

spliced into pre wired installation, use wire

nuts or other suitable connectors.

To Opener

Wire to Opener

Connecting Wired Infrared Safety

Sensor to Opener

Tools Needed:

Phillips Head

Screwdriver

Connect infrared safety sensors to the

opener as shown. Shorten wires as

necessary and separate wire ends. Strip

about 1/2” of insulation off each wire and

attach wires to the proper terminal screws,

then tighten securely, using phillips head

screwdriver.

One wire has marking on it (numbers, black

stripe, etc). Be sure to observe polarity. Apply

tension to external wires to test for secure

connection. Check that the wires are stapled

in place properly.

P.B.

COM

OBS

Sending Unit

Receiving Unit

Black Strip

Solid

Color

Right Side Of Opener

LED

PRE-OPERATION

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 45 46

Comments to this Manuals

No comments

Wayne 3018DLX Owner's Manual Page 17

Comments to this Manuals

Related products and manuals for Garage Door Opener Wayne 3018DLX